Ats-20 | Radio Manual

(Beat Frequency Oscillator) adjustment for fine-tuning SSB signals. Band Selection

Turn the after power-on. There is no digital volume display.

Adjust using the dedicated knob or through the digital interface (depending on your specific firmware version). 3. Selecting Modes and Bands ats-20 radio manual

: The ATS-20/25 Facebook Group is the primary hub for troubleshooting and finding the latest firmware files.

“FINAL STEP: Turn the volume knob fully counter-clockwise until you feel a click past ‘0.’ This is not ‘MUTE.’ This is ‘MEMORY.’ The radio will then listen to you. Speak your deepest secret into the silence. The ATS-20 will broadcast it once, on every frequency, for one second, to every receiver on Earth. This cannot be undone. Do not turn the knob past ‘0’ unless you are prepared to be truly heard.” Adjust using the dedicated knob or through the

Then the floods came. Power failed. Internet died. Cell towers went silent. Maya grabbed her radio and batteries, turned it on… and got nothing but white noise across every band.

: If the radio behaves strangely after a firmware flash, turn it on while holding the encoder button down to reset the memory to defaults. Antenna Performance : While the included telescopic whip is decent for FM, an external wire antenna “FINAL STEP: Turn the volume knob fully counter-clockwise

: Attach the included rubber feet to the bottom of the metal case to prevent sliding. Antenna Connection : Connect the telescopic antenna to the BNC connector