How To Open Fastboot Mode On Tecno Spark 6 Go -

and allow the USB debugging prompt on the phone (tap "OK").

To open fastboot mode on a Tecno Spark 6 Go, you must first enter Recovery Mode and then select the fastboot option from the menu Manual Method via Key Combination : Press and hold the Power button and select "Power off" to completely shut down the device. Trigger Boot : Simultaneously press and hold the Power buttons for several seconds. Logo Release : When the Tecno logo appears on the screen, release the Power button but continue holding No Command Screen : Release the Volume Up button how to open fastboot mode on tecno spark 6 go

Below are the only two reliable methods to enter Fastboot Mode on the Tecno Spark 6 Go. and allow the USB debugging prompt on the phone (tap "OK")

If the phone boots normally, you released the buttons too early. Repeat steps 1–5. Logo Release : When the Tecno logo appears

Press the Power button to select it. Your phone will boot into Fastboot Mode. Method 2: Using ADB Commands (Requires a PC)

Use this method if your phone can boot into the operating system and you have USB debugging enabled.