Cut the tracks in a way that allows you to bridge them with a drop of solder if you cut the wrong ones. Common Failure Symptoms & Fixes
Use a small piece of clear Scotch tape to cover the clock signal pins (typically CKV, CKVB, and STVP ) on the faulty ribbon cable's connector. ltf320ap11 panel repair
: On the panel's PWB (Printed Wire Board), locate and remove the zero-ohm resistors (often labeled RM1–RM7) that transmit these signals to the glass. Cut the tracks in a way that allows
If the T-Con voltages are correct but the image is still distorted (e.g., double images), the fault is likely internal to the panel's glass. If the T-Con voltages are correct but the
Sometimes cutting the traces stops the double image but leaves minor flickering or ghost lines. The ultimate fix used by expert panel repairers is to clean the trace on the isolated side and jump a tiny enamel wire from the cut CKV / CKVB lines directly to (Ground) or
